1.产品特
可编程胎压传感器说明书
User manual
点
TPS800-1 型可编程胎压传感器是配合 TPS800 胎压编程器使用的胎压传感器，该胎压传
感器具有体积小，重量轻的特点。
TPS800-1 型可编程胎压传感器可以通过 TPS800 胎压编程器根据用户车型需求编程各种
车型的胎压传感器软件，从而支持失眠上 95%车型使用。
2.产品参数
电压 ：3.0V
电流 ：静态 500nA
发送 8mA
防水等级：IP67
使用寿命：3 年
材质；PA66 + GF30
Programmable Tire Pressure Sensor Manual
1. Product Features
The TPS800-1 programmable tire pressure sensor is designed for use with the TPS800 tire
pressure programmer, featuring a compact size and lightweight design.
The TPS800-1 programmable tire pressure sensor can be configured with software for
various vehicle models via the TPS800 tire pressure programmer based on user requirements,
supporting installation on 95% of vehicle models.
2. Product Parameters
Voltage: 3.0V
Current: Static 500nA
Send 8mA
Waterproof Rating: IP67
Service life: 3 years
material PA66 + GF30
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
