Battery capacity
Size
180mah
260mah
Drumsticks
Pedal
2 in 1 speaker
1
11
3
3
3
3
.
①
②
③
④
⑤
⑥
If a significant deviation is found in the drum layout
position during the tapping process, please perform
sensor calibration. (This step should be executed
with caution, and if you have any questions, please
contact the customer.)
Here are the steps for initializing and calibrating the
drum stick sensors:
1.1 Press and hold the drum stick power button until the
status indicator light flashes from red to green.
1.2 Hold the drum stick and draw an "∞" symbol in the air
.
The indicator on the drum stick will change from green to
blue, and then the stick will power off.
1.3 Power on the drum stick again and check the drum
position against the instructions. If there is still a
significant difference, please repeat this step. (If you
have any questions, please contact customer service.)
1.4 The demonstration diagram of drawing the "∞"
symbol with the drum stick is provided below.
Sensor calibration instructions
7
FCC Warning:
FCC Warning:
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution:
Any
changes
or
modifications
to
this
device
not
explicitly
approved
by
manufacturer
could void your authority to operate this equipment.
This
device
complies
with
part
15
of
the
FCC
Rules.
Operation
is
subject
to
the
following
two
conditions:
(1)This
device
may
not
cause
harmful
interference,
and
(2)
this
device
must
accept
any
interference received, including interference that may cause undesired operation.
This
equipment
complies
with
FCC
radiation
exposure
limits
set
forth
for
an
uncontrolled
environment.
This
equipment
should
be
installed
and
operated
with
minimum
distance
0cm
between the radiator and your body.
