Loading ...
Loading ...
Loading ...
WARNING: Never use your hands to clean snow
and ice from the chute assembly or auger housing.
Chute Clean-Out
Tool
Figure 3-14
Drift Cutters (If Equipped)
Drift cutters should be used when operating the snow thrower in
heavy drift conditions.
• On models so equipped, drift cutters and hardware are
assembled to the auger housing inverted.
• Remove the carriage bolts and wingnuts securing the drift
cutters to the housing.
• Reposition drift cutters so they face forward as shown
in Fig. 3-15. Secure with hardware previously removed,
wingnuts should be fastened on the outside of the housing
as shown.
Figure 3-15
Figure 3-12
Set-Up
Shear Pins Storage (if so equipped)
On some models an area for convenient shear pin storage is
located at the rear of the plastic dash panel. See Fig. 3-13.
Figure 3-13
Clean-Out Tool
The clean-out tool is mounted to the rear of the auger housing
and is designed to clear a clogged chute. Refer to page 14 for
instructions on how to properly use it.
NOTE: This item is fastened with a cable tie to the rear of the
auger housing at the factory. Cut the cable tie before operating
the snow thrower. See Fig. 3-14.
10 Section 3— ASSembly & Set-Up
Loading ...
Loading ...
Loading ...