Loading ...
Loading ...
Loading ...
6 en | Safety FLEXIDOME IP starlight 8000i
2021-02 | V02 | F.01U.385.211
Installation manual
Bosch Security Systems B.V.
– Operate the device only from the type of power source indicated on the label.
i
Notice!
Do not attempt to service this product. Refer all servicing to qualified service personnel.
– Install in accordance with the manufacturer's instructions in accordance with applicable
local codes.
– Use only attachments/accessories specified by the manufacturer.
– Protect all connection cables from possible damage, particularly at connection points.
All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at
least 3mm / 0.12in, into the electrical installation of the building. If it is needed to open the
housing, use this all-pole switch as the main disconnect device for switching off the voltage to
the unit.
Camera signal - Protect the cable with a primary protector if the camera signal is beyond
42.7meters /140feet, in accordance with NEC800 (CEC Section 60).
Fuse rating - For security protection of the device, the branch circuit protection must be
secured with a maximum fuse rating of 16A. This must be in accordance with NEC800 (CEC
Section 60).
Outdoor signals - The installation for outdoor signals, especially regarding clearance from
power and lightning conductors and transient protection, must be in accordance with NEC725
and NEC800 (CEC Rule 16-224 and CEC Section 60).
Video loss - Video loss is inherent to digital video recording; therefore, Bosch Security
Systems cannot be held liable for any damage that results from missing video information.
To minimize the risk of losing information, we recommend multiple, redundant recording
systems, and a procedure to back up information.
1.4 Power connection in applications
24VAC / 12-26VDC power source: This unit is intended to operate with a limited power
source. The unit is intended to operate at 24VAC or 12-26VDC (if PoE is not available). User
supplied wiring must be in compliance with electrical codes (Class 2 power levels).
PoE: Use only approved PoE devices. Power-over-Ethernet can be connected at the same time
as a 24VAC or 12-26VDC power supply. The power supply can work as backup power source
in case of PoE power drops.
1.5 Notices
i
Notice!
This device is intended for use in public areas only.
U.S. federal law strictly prohibits surreptitious recording of oral communications.
UL Disclaimer
Underwriter Laboratories Inc. ("UL") has not tested the performance or reliability of the
security or signaling aspects of this product. UL has only tested fire, shock and/or casualty
hazards as outlined in Standard(s) for Safety for Information Technology Equipment, UL
60950-1, UL 62368-1, UL 60950-22. UL Certification does not cover the performance or
reliability of the security or signaling aspects of this product.
Loading ...
Loading ...
Loading ...