Loading ...
Loading ...
Loading ...
28
OPERATION
When using the steam mode, a constant amount of
water is supplied regardless of the operation of the
water adjustment buttons.
•
High Mode
: Press the
High Mode
button
a
all
the way down to clean ingrained dirt or supply a
large amount of water.
•
Low Mode
: Press the
Low Mode
button
b
all the
way down to supply a small amount of water for
cleaning wood or other flooring that can be
damaged by too much water.
•
STOP
: Press the
Low Mode
or
High Mode
button halfway to toggle back to the
STOP
position. This stops the supply of water so you
can go over areas that are already wet.
Using with the Hot Mop Nozzle
• When using the steam mode, a constant amount
of water is supplied regardless of the operation
of the water adjustment buttons.
• Insert the water tank filled with water into the
hot mop nozzle, attach the mop pads soaked in
water, and then insert the battery pocket.
1
Insert the battery pocket
b
into the hot mop
nozzle
c
, and insert the fully charged spare
battery
a
into the battery pocket
b
. Push the
battery pocket and the battery all the way in
until a click is heard.
2
Insert the hot mop nozzle into the extension
pipe and connect it to the product body. When
you press the
Power
button
d
on the product
body, the steam mode will be turned on and
preheating will begin.
• During preheating, the nozzle front LED will
blink.
• When you turn on the steam mode, the
steam generator will be preheated for about
40 seconds and the steam will heat up the
wet mop pads. Begin cleaning when the red
battery pocket LED turns on.
• Whilst steam is heating up the wet mop
pads, after preheated, the steam may not be
visible. It takes about 80 seconds for the
mop pads to be heated to about 60
7
.
Charging the Battery and Storing
the Hot Mop Nozzle
1
When cleaning is finished, press the
Power
button on the product body to turn the product
off.
2
The battery pocket does not have a charging
function. Separate the battery from the battery
Loading ...
Loading ...
Loading ...