Loading ...
Loading ...
Loading ...
BLAZE Instructional
Book Page | 25
ALL GAS CONNECTION POINTS SHOULD BE TESTED FOR LEAKS AFTER
INSTALLATION PRIOR TO
FIRST USE OF THE GAS APPLIANCE(S).
Before installing an appliance in any island cut out, make sure that the opening is not bigger than the outside
frame of the appliance unit. The appliance should rest on the lip of the frame.
Pay careful attention to the location of the gas line. It should be routed away from sources of heat, sharp edges
an
d aggressive surfaces
and should ma
ke as few bends as possible.
Ensure the gas line connection will be accessible when appliance is installed. A safety shutoff valve is required at
this
gas connection point.
PLEASE NOTE: An enclosure for an gas shall be ventilated by openings at both the upper and lower levels of
the enclosure. At least two ventilation openings shall be provided in the side wall of the enclosure, located
within 5 in (217 mm) of the top of the enclosure at a minimum of 90 degrees (1.57 rad), and unobstructed. Also,
ventilation opening(s) shall be provided at floor level of the enclosure. If ventilation openings at floor level are
in a side wall, there shall be at least two openings. The bottom of the openings shall be 1 in (25.4 mm) or less
from the floor level and the upper edge no more than 5 in (127 mm) above the floor level. Every opening shall
have minimum dimensions so as to permit the entrance of a 1/8 in
(3.2 mm) diameter rod. Ventilation openings in side walls shall not communicate directly with other enclosures
of the outdoor cooking gas appliance.
The burner must be double checked for the correct placement in the appliance before operation. When finished
ensure that the burner is aligned in the bracket slot. Failure to do so could result in a fire and injury.
If the outdoor kitchen countertop will overhang the face of the island, notching out the two front countertop edges
will be necessary to allow the double burner to slide flush against the outer front wall to the outdoor kitchen. Due
to differing personal preferences of the size of the notch out, this is recommended to be done at the point of
installation so that the consumer can dictate their preference.
• Slide the appliance into the cut
out and then attach the gas line.
Loading ...
Loading ...
Loading ...