Loading ...
Loading ...
Loading ...
- 6 -
Mounting on Dashboard
See the section “Installation Precautions”. (P.3)
Use only installation parts provided with the product. Using other mounting
methods may void the warranty.
Before you drill or cut any holes, investigate your vehicle’s layout very carefully.
Take special care when you work near the fuel tank, fuel lines, hydraulic lines
and electrical wiring.
1. In the dashboard, cut a mounting hole (W x H): 3.86” x 3.98” (98 x 101 mm).
2. Remove the left and right trim plates from the front panel.
3. Fasten the unit to the dashboard with four supplied screws. Then replace the trim plates.
Cutout (W x H): 3.86” x 3.98” (98 x 101 mm)
Right trim plate
Left trim plate
Wiring
See the section “Installation Precautions”. (P.3)
Disconnect the negative terminal of the vehicle battery prior to wiring.
Connect the unit to a 12VDC battery and negative ground only.
To prevent a short circuit, the positive battery terminal must be connected to the
wires through a fuse (minimum 15A).
Never ground or short the speaker wires.
Insulate all bare wires and unconnected wires with electrical tape.
Loading ...
Loading ...
Loading ...