Loading ...
Loading ...
Loading ...
en Rails
36
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→"Basic settings", Page26
¡ The pull-out rails can be installed at any level as re-
quired.
¡ If necessary, you can equip all levels with a pull-out
rail.
1.
Push on the side of the tab marked PUSH behind
the rail, and push the rail to the rear.
2.
Press and hold PUSH and swing the rail out-
wards until the front retainer is detached.
a
3.
Pull the rail out towards the front.
4.
Remove the pull-out rail.
5.
Clean the pull-out rail.
→"Cleaning products", Page29
Note:
Further information:
23.4 Attaching the pull-out rail
Note:The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Guide the pull-out rail with the rear retainer
from
below behind the two guide rods for the required
shelf position and keep it horizontal.
2.
Guide the rail lengthways to the rear to the guide
rods, and slide both retainers onto each lower rod.
In doing so, use the rear retainer to grip the ver-
tical rod.
Loading ...
Loading ...
Loading ...