Loading ...
Loading ...
Loading ...
8
m WARNING: The burner control knobs must be
in the OFF position before turning on the liquid
propane tank valve. If they are not in the OFF
position, when you turn on the LP tank valve,
the “excess gas flow control” feature will
activate, limiting the flow of gas from the LP
tank. If this should occur, turn o the LP tank
valve and burner control knobs. Start over.
m DANGER: When the “excess gas flow control”
feature is activated, a small amount of gas is
still flowing to the burners. After turning o
the tank and burner control knobs, wait at
least five minutes for the gas to clear before
attempting to light the grill. Failure to do so
may result in an explosive flare-up, which can
cause serious bodily injury or death.
m WARNING: Do not operate the grill with the
lid closed. The lid is to be used for storage
purposes only to protect the griddle.
m WARNING: Open lid during ignition. Failure to
open the lid while igniting the grill’s burners,
or not waiting five minutes to allow the gas to
clear if the grill does not light, may result in
an explosive flare-up which can cause serious
bodily injury or death.
m WARNING: Do not lean over open grill while
igniting or cooking.
m WARNING: Each burner must be ignited
individually using the snap ignition.
m WARNING: If ignition does not occur within
four seconds of attempting to light the first
burner, turn the burner control knob to the o
position and repeat the lighting procedure a
second time. If the burner still does not light,
turn the burner control knob to OFF and wait
five minutes to let the gas clear before you try
again or try to light with a match.
Igniting the Grill
Using the Snap Ignition System to Ignite the
Burners
Each control knob snap igniter creates a spark from
the igniter electrode to the burner lighting tube. You
generate the energy for the spark by pushing in the
control knob and turning it to the start/high position.
Each control knob operates an individual burner, and
each burner ignites independently. Ignite the burners
starting from left to right. All burners should be lit for
preheating, however, all burners do not have to be lit
while cooking.
1) Remove the protective hard cover (A).
m WARNING: Do not operate the grill with the hard
cover closed. The hard cover is to be used for
storage purposes only to protect the griddle.
2) Check that all burner control knobs are in the o
position. Check by pushing in and turning knobs
clockwise (B).
Note: It is important that all burner control knobs are
in the o position before turning on the LP tank.
If they are not, the flow limiting device built into the
regulator will activate, limiting the flow of gas from
the LP tank.
3) Turn the LP tank on by slowly turning the tank valve
counterclockwise; wait 60 seconds (C).
Note: It is important that the LP tank is turned on
slowly. Ifit is opened too quickly, the flow limiting
device built into the regulator will activate, limiting the
flow of gas from the LP tank.
4) Begin with the burner furthest to the left.
Push the burner control knob in (D) and turn it
counterclockwise to the start/high
position until
you hear it snap (E). Continue to hold the control
knob in for two seconds after you hear the snap.
This action will spark the igniter within the burner
lighting tube, then light the main burner (F) (G) (H).
5) Check that the burner is lit by looking through the
space in between the cooking surface and the
control panel.
6) If the burner does not ignite, turn burner control
knob to the o
position and repeat the lighting
procedure a second time. If the burner still does not
light, turn the burner control knob to OFF and wait
five minutes to let the gas clear before you try again
or try to light with a match.
7) If the burner ignites, repeat steps 4 through 6 to
light the remaining burners.
Should the burners fail to ignite using the electronic
ignition, refer to the TROUBLESHOOTING section in
this Owner's Guide. Thereyou will find instructions on
igniting the grill with a match to help determine the
exact problem.
To Extinguish Burners
1) Push each burner control knob in and then turn
clockwise all the way to the o position.
2) Turn gas supply o at the LP tank.
C
B
D
E
F
G
H
A
OFF
LOW
MEDIUM
START/HIGH
Operation
Loading ...
Loading ...
Loading ...