Loading ...
Loading ...
Loading ...
6
Getting Started
LP Tank Installation
The tank is hung onto the tank bracket which is located
on the right side of grill. The shape of the collar
assembly (the metal protective ring around the tank
valve) determines one of two directions in which the
tank will correctly hang on the tank scale (A).
Inspect the Tank
1) Confirm that the tank valve is fully closed. Close by
turning valve clockwise.
2) Confirm that the tank valve is the proper mating
type for the regulator (B).
3) Inspect the tank valve, including the internal rubber
seal for damage or debris (C). If damaged, return
tank to local retailer.
Install The Tank
1) Check that all burner control knobs are in the
o
position. Check by pushing in and turning
knobs clockwise.
2) The tank is hung by the collar assembly (the metal
protective ring around the tank valve) onto the tank
bracket (D).
3) To make the tank connection: Pass the hose and
regulator through the hole on the right-side panel
(E). The hose must be secured with the retention
clip and attached to the side panel. Make sure the
full length of hose is pulled to the outside before
tightening the clip.
4) Screw the regulator coupling onto the tank valve,
turning clockwise (F). Hand-tighten only. Using a
wrench could damage the regulator coupling and
could cause a leak. Proceed to “CHECKING FOR
GASLEAKS.”
B
C
D
F
A
m DANGER: The hose must pass through the
opening on the right-side panel. The hose
must be secured to right side panel using
the hose retention clip. Failure to do so could
cause damage to the hose resulting in a fire
or explosion which can cause serious bodily
injury or death.
E
Loading ...
Loading ...
Loading ...