1. Home
  2. Weber
  3. Weber 1500013 User Manual
  4. Page 13

Weber 1500013 Slate Rust-Resistant Griddle

Owner’s Manual - Page 13

For 1500013.

PDF File Manual, 16 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
13
Troubleshooting
MAIN BURNER(S) WILL NOT IGNITE
SYMPTOM
• Main burners do not ignite when following the ignition instructions in the “Operation” section of this owner's manual.
CAUSE SOLUTION
There is a problem with gas flow. If any burner does not ignite, the first step is to determine if there is gas flowing to the burner(s). Tocheck
this, follow the instructions below for “Lighting Your Grill with a Match.”
If match lighting IS NOT successful, follow the “GAS FLOW” troubleshooting suggestions on the next page.
There is a problem with the ignition system. If any burner does not ignite, the first step is to determine if there is gas flowing to the burner(s). Tocheck this,
follow the instructions below for “Lighting Your Grill with a Match.”
If match lighting IS successful, contact customer service about checking the ignitionsystem.
B
D
Lighting Your Grill with a Match
Using a Match to Determine if there is Gas Flow
to the Main Burners
1) Remove the protective hard cover (A).
m WARNING: Do not operate the grill with the hard
cover closed. The hard cover is to be used for
storage purposes only to protect the griddle.
2) Check that all burner control knobs are in the o
position. Check by pushing in and turning knobs
clockwise.
Note: It is important that all burner control knobs are
in the o
position before turning on the LP tank.
If they are not, the flow limiting device built into the
regulator will activate, limiting the flow of gas from
the LP tank.
3) Turn the LP tank on by slowly turning the tank valve
counterclockwise; wait 60 seconds.
Note: It is important that the LP tank is turned on
slowly. Ifit is opened too quickly, the flow limiting
device built into the regulator will activate, limiting the
flow of gas from the LP tank.
4) Begin with the burner furthest to the left. Put
match in the matchstick holder and strike match.
(Matchstick holder is located under left side table.)
Insert lit match down bewteen the flat top cooking
surface and the grill frame, next to the burner(B).
5) Pushthe burner control knob in and slowly turn it
counterclockwise to the start/high
position (C).
6) Confirm that the burner is lit by looking bewteen the
griddle and the grill frame.
7) If the burner does not ignite within 4 seconds,
turn burner control knob to the o
position and
wait five minutes to allow the gas to clear before
attempting to light the burner again. If repeated
attempts fail, follow the gas flow troubleshooting
instructions on the next page.
8) If the burner ignites, the problem may be with the
ignition system. Contact WEBER customer service
about checking the ignitionsystem.
9) Replace the matchstick holder by hanging
underneath left side table (D).
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the CustomerService
Representative in your area using
the contact information on
weber.com.
A
C
Loading ...
Loading ...
Loading ...