Loading ...
Loading ...
Loading ...
en-us Troubleshooting
28
Issue Cause and troubleshooting
Four vertical LED's (i.e. the cycle
duration indicators and the clean
indicator) all light up at the same
time.
Filters in the water connection of the supply or AquaStop hose are blocked.
1. Switch off the appliance.
2. Pull out the power cord plug.
3. Turn off the water faucet.
4. Unscrew the water connection.
5. Remove the filter from the supply hose.
6. Clean the filter.
7. Reinsert the filter in the supply hose.
8. Screw the water connection back on.
9. Check the water connection for leaks.
10.Restore the power supply.
11.Switch the appliance on.
Inlet hose is kinked.
▶ Install the inlet hose without kinks.
Water faucet is turned off.
▶ Turn on the faucet.
Four vertical LED's (i.e. the cycle
duration indicators and the clean
indicator) are all flashing.
There is a technical issue.
1. Press
.
2. Pull out the power cord plug of the appliance or switch off the breaker.
3. Wait at least 2minutes.
4. Insert the power cord plug of the appliance in a power outlet or switch on the
breaker.
5. Switch the appliance on.
6. If the problem occurs again:
‒ Press
.
‒ Turn off the water faucet.
‒ Pull out the power cord plug.
‒ Contact customer service →
Page35
and give the error code.
Dishware is not dry. No rinse aid used or dosage set too low.
1.
Add Rinse aid →
Page14
.
2. Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page15
Cycle or cycle option has no drying phase, or drying phase is too short.
▶
Select a wash cycle with drying. →
Page10
Some option buttons decrease the drying result.
Loading ...
Loading ...
Loading ...