Loading ...
Loading ...
Loading ...
Operation
5
12
NOTE: This Operator’s Manual covers several models. Features may vary
by model. Not all features in this manual are applicable to all models and
the model depicted may differ from yours.
Pre-Start Checklist
1. Remove the vented dipstick and check hydraulic fluid level.
Refill if necessary. Approved fluids include Shell Tellus® S2 M 32
Hydraulic Fluid, Dexron® III/Mercon® Automatic Transmission Fluid,
Pro-Select™ AW-32 Hydraulic Oil or 10WAW-ISO Viscosity Grade 32
Hydraulic Oil. Check the engine oil level. Refill if necessary.
2. Check the engine oil level. Refill if necessary.
3. Fill up with gasoline if necessary.
4. Lubricate the beam area where the splitting wedge will slide with
engine oil using a clean rag. Do not use grease to lubricate. Make
sure to lubricate both the front and the back of the beam face.
5. Attach the spark plug wire to the spark plug.
Starting the Engine
Refer to the Engine Operator’s Manual for detailed starting instructions.
WARNING! Read, understand and follow all the
instructions and warnings on the machine and in included
in the Operator’s Manuals before operating.
Using the Log Splitter
WARNING! Wear work gloves, safety shoes, ear
protection and safety glasses when operating the log
splitter. Ensure safe footing.
Operating Positions
1. Place the log splitter on flat, dry, solid ground.
2. Block the front and back of both wheels. See Figure 5-1.
Horizontal
Vertical
Figure 5-1
3. Place the beam in either the horizontal or vertical position and
lock into place.
WARNING! Take extra care when raising and lowering
the beam as it is heavy. Having a second person assist with
raising or lowering the beam is recommended. Be sure to
keep hands away from any possible pinch points.
4. To place the beam in the vertical position, proceed as follows:
WARNING! Always use the log splitter in the vertical
position when splitting heavy logs.
a. Pull the horizontal beam lock out to release the beam and
pivot the beam to the vertical position.
b. To lock the beam in the vertical position, pull out on the
vertical beam lock and rotate it to secure the beam. See
Figure 5-2.
Vertical Beam Lock
1
2
Figure 5-2
Loading ...
Loading ...
Loading ...