Loading ...
Loading ...
Loading ...
10 Section 3— ASSembly & Set-Up
5. Disconnect the spark plug and prime the pump by pulling the recoil
starter as far as it will go. Repeat approximately 10 times.
NOTE: Close the fuel shut-off valve (if equipped) before performing
Step 5 to avoid engine flooding.
6. Reconnect the spark plug wire and start the engine following
instructions in the Engine Operator’s Manual.
7. Use the control handle to engage the wedge to the farthest
extended position. Then retract the wedge.
8. Refill the tank as specified on the dipstick if necessary.
NOTE: Failure to refill the tank will void the log splitter’s warranty.
9. Extend and retract the wedge 12 complete cycles to remove any
trapped air in the system (the system is “self-bleeding”).
10. Refill the reservoir within the range marked on the dipstick if
necessary.
NOTE: Some fluid may overflow from the vent plug as the system
builds heat and the fluid expands and seeks a balanced level.
Tire Pressure
The max recommended operating pressure is 30 psi. Do not under any
circumstances exceed the manufacturer’s recommended psi. Maintain
equal pressure in both tires.
WARNING! Excessive pressure when seating beads
may cause tire/rim assembly to burst with force sufficient
to cause serious injury.
Loading ...
Loading ...
Loading ...