Loading ...
Loading ...
Loading ...
20
Gas hook-up
LP tank restraint for built in installation
If the grill is to be installed in a built-in application, then the grill must be installed in accordance
with the built–in installation guidelines.
If you intend to operate your built-in grill on LPG gas utilising a minimum 9 kg cylinder, then the
built-in LPG cylinder restraint must be installed prior to initial use of the grill. If you do not have one
please contact DCS by Fisher & Paykel for information on obtaining one. See section ‘Service’ for
contact details.
The following steps will illustrate how to properly locate and install the LPG cylinder restraint within
the built-in enclosure.
IMPORTANT!
y The grill comes with the LPG Regulator/Hose assembly installed at the factory. The assembly, along
with the entire grill system, is leak tested.
y Do not remove the Regulator/Hose assembly from the grill during installation.
y Install the supplied CLIP HOSE 5/8 - 7/8 SS (LP units only).
y Whenever the LPG Regulator/Hose assembly is not connected to the LPG cylinder, the clip can
be used to hold it to prevent the hose from getting pinched and to keep the inlet from getting
contaminated or damaged.
Fig. 09
Centre of cylinder restraint must be
placed within this area to avoid causing
stress on the LPG regulator hose con-
nection.
The maximum distance from the center
of the manifold cut out to the center of
the tank restraint is 457mm.
Center of manifold
cut out projected to
floor of the island.
457mm max
INSTALLATION
Loading ...
Loading ...
Loading ...