Loading ...
Loading ...
Loading ...
Fig. 47
u
Slide the soft stop mechanism on the bearing
bracket side at an angle into the recess as far as it
will go. Fig. 47 (1)
u
Slide the unit in fully.
w
The unit is positioned correctly when the rib on the
soft stop unit is in the guide on the housing.
u
Tighten the screw using a T15 screwdriver. Fig. 47 (2)
Fig. 48
The door is open 90°.
u
Turn the hinge in the bearing bracket. Fig. 48 (1)
u
Insert the bolt in the bearing bracket and hinge.
Make sure that the latching lug is sitting correctly in
the groove. Fig. 48 (2)
u
Remove the locking device. Fig. 48 (3)
Fig. 49
u
Position the bearing bracket cover and engage it. If
necessary push it apart carefully. Fig. 49 (1)
u
Place on the panel. Fig. 49 (2)
u
Swing in the panel and latch it into place. Fig. 49 (3)
u
Slide on the outer cover. Fig. 49 (4)
u
Close the upper door. Fig. 49 (5)
14 Water connection*
WARNING
Electricity and water!
Electric shock
u
Before connecting to the water hose: Disconnect the
appliance from the mains.
u
Before connecting to water lines: Shut off the water
supply.
u
The drinking water connection may only be carried
out by a qualified gas and water installer.
WARNING
Contaminated water!
Poisoning.
u
Connect to potable water supply only.
The appliance’s water connection and inlet solenoid
valve are suitable for a water pressure of up to 1 MPa
(10 bar).
Specifications for proper operation (flow rate, ice cube
size, noise level):
Water connection*
22 * Depending on model and options
Loading ...
Loading ...
Loading ...