Loading ...
Loading ...
Loading ...
u
Insert the cover and press it down until it latches
into place. Fig. 40 (5)
u
Insert the plugs. Fig. 40 (6)
13.13 Fitting the cable connection
Fig. 41
u
Take out the control panel carefully. Fig. 41 (1)
u
Turn the panel upward through 180°. Fig. 41 (2)
u
Engage the plug on the control panel. Fig. 41 (3)
u
Latch the control panel into the appliance again.
Fig. 41 (4)
u
Carefully position the gray cable in the guide above
the top bearing bracket. Fig. 41 (5)
Fig. 42
u
Insert the gray cable into the guide in the top door.
Fig. 42 (1)
u
Press the latching lug backward Fig. 42 (2)
u
Engage the plug. Fig. 42 (3)
u
Position the remaining cable length as a loop in the
guide, if required.
13.14 Aligning the doors
WARNING
Danger of injury due to door falling out!
If the bearing parts are not screwed on tightly enough,
the door may fall out. This can result in serious injuries.
In addition, the door may not close causing the appli‐
ance to cool improperly.
u
Screw the bearing brackets on tightly using
4 Nm (3 lb-ft) .
u
Check all screws and retighten them if necessary.
u
Align the doors flush with the appliance housing
using the two slots in the lower bearing bracket and
center bearing bracket if needed. To do this undo the
middle screw in the bottom bearing bracket with the
T20 tool supplied. Undo the remaining screws a little
with the T20 tool or with a T20 screwdriver and align
via the slots. Undo the screws in the middle bearing
bracket with the T20 tool and align the middle
bearing bracket via the slots.
u
Prop up the door: Screw out the adjustable foot on
the bearing bracket using the open-ended wrench
SW10 until it comes into contact with the floor, then
turn an additional 90°.
Reversing the door
20 * Depending on model and options
Loading ...
Loading ...
Loading ...