Loading ...
Loading ...
Loading ...
AXIS Q1604 Network Camera
Hardware overview
1.
Power LED
2.
Network LED
3.
Control b utton
4.
Iris connector
5.
Power connector
6.
I/O terminal connector
Connectors
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet (PoE).
Caution
Due to local regulations or the environmental and electrical conditions in which the product is to be used, a shielded
network cable (STP) may be appropriate or requir
ed. Any network cables that are routed in outdoor environments or similar
shall be shielded (STP) and intended for their specific use. Make sure that the network switch is properly grounded. See
for regulatory requirements.
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in m ono signal (left channel is used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address (PA) system or an active speaker
with a built-in amplifier. A stereo connector must be used for the audio out.
SD card slot - A standard or high-capacity SD card (not included) can be used for local recording with removable storage. For
instructions on how to insert and remove an SD card, please r efer to the Installation Guide.
Note
Before removal, the SD card should be unmounted to prevent corruption of recordings. To unmount the SD card, go to Setup
>System
Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
5
Loading ...
Loading ...
Loading ...