Troy-Bilt 11A-A22Q563 Push Lawn Mower

Operator’s manual - Page 18

For 11A-A22Q563. Series: A20 Series
Also, The document are for others Troy-Bilt models: A00, A10, A20, B00, B10, B20

PDF File Manual, 44 pages, Read Online | Download pdf file

11A-A22Q563 photo
Loading ...
Loading ...
Loading ...
Troubleshooting
8
18
Problem Cause Remedy
Engine Fails to start Blade control disengaged.1.
Spark plug boot disconnected.2.
Fuel tank empty or stale fuel.3.
Engine not primed (if equipped with primer). 4.
Faulty spark plug.5.
Blocked fuel line.6.
Engine flooded. 7.
Fuel valve (if equipped) closed.8.
Engine not choked (if equipped with choke).9.
Burnt fuse. (Electric Start Only).10.
Engage blade control.1.
Connect wire to spark boot.2.
Fill tank with clean, fresh gasoline.3.
Prime engine as instructed in the Operation 4.
section.
Clean, adjust gap, or replace.5.
Clean fuel line.6.
Wait a few minutes to restart, but do not 7.
prime.
Open fuel valve. See engine manual.8.
Choke engine. See engine manual.9.
Replace fuse. (See Maintenance Section).10.
Engine runs erratic Spark plug boot loose.1.
Blocked fuel line or stale fuel. 2.
Vent in gas cap plugged.3.
Water or dirt in fuel system.4.
Dirty air cleaner.5.
Unit running with CHOKE applied or in the 6.
“ON” position (if equipped).
Connect and tighten spark plug boot.1.
Clean fuel line; fill tank with clean, fresh 2.
gasoline.
Clear vent.3.
Drain fuel tank. Refill with fresh fuel.4.
Refer to engine manual.5.
Put CHOKE in the “OFF” position..6.
Engine overheats Engine oil level low.1.
Air flow restricted.2.
Fill crankcase with proper oil.1.
Clean area around and on top of engine.2.
Occasional skips (hesitates)
at high speed
Spark plug gap too close.1. Adjust gap to .030”. Refer to engine manual.1.
Idles poorly Spark plug fouled, faulty, or gap too wide.1.
Dirty air cleaner.2.
Reset gap to .030” or replace spark plug.1.
Refer to engine manual.2.
Excessive Vibration Cutting blade loose or unbalanced.1.
Bent cutting blade.2.
Tighten blade and adapter. Balance blade.1.
See an authorized service dealer.2.
Mower will not
mulch grass
Wet grass. 1.
Excessively high grass. 2.
Dull blade.3.
Do not mow when grass is wet; wait until 1.
later to cut.
Mow once at a high cutting height, then mow 2.
again at desired height or make a narrower
cutting path.
Sharpen or replace blade.3.
Uneven cut Wheels not positioned correctly. 1.
Dull blade.2.
Place front and rear wheels in same height 1.
position.
Sharpen or replace blade.2.
Loading ...
Loading ...
Loading ...