Loading ...
Loading ...
Loading ...
51
EN
Cleaning and maintenance
Draining residual water (St1)
1) The appliance removes the residual
water by draining it into the compartment
on the right.
2) Press the release button on top of the lid
and pull to open.
3) Lift the handle, remove the reservoir and
empty it.
Caution
The water may be very hot.
Filling the reservoir with descaler solution
(St2)
1) Fill the filling compartment on the left
with a solution of water and descaler
according to the manufacturer’s
recommendations.
Caution
Do not fill the water drainage
compartment on the right.
Use cold tap water which is not
too hard, softened water or still
mineral water.
Do not use distilled water, tap
water with a high chloride
content (> 40 mg/l), or other
liquids.
2) Place the reservoir in the oven
compartment and close the lid.
It is now no longer possible to
cancel the descaling cycle.
Starting the descaling function (St3)
1) Press the SET button to confirm.
2) The appliance starts the boiler cleaning
procedure and the display shows the
entire duration of the procedure.
During the descaling process,
the appliance will pause a few
times to allow the descaler to act
effectively. Wait for the cycle to
end.
Draining the descaler solution (St4)
1) At the end of the cleaning process,
the appliance drains the remaining
descaler solution into the drainage
compartment of the reservoir.
2) Remove the reservoir and empty the
descaler solution.
Caution
The descaler solution may still be
very hot.
Loading ...
Loading ...
Loading ...