Loading ...
Loading ...
Loading ...
13
2.3.2.2 IN-CEILING INSTALLATION
The In-Ceiling Installation is mounting the camera into the ceiling with IBP3BBAP-EI, a Sarix Environmental In-Ceiling
Mount for bullet.
FIGURE 2-5: IN-CEILING INSTALLATION WITH IBP3BBAP-EI
1. Make a round hole for IBP3BBAP-EI backbox (#1) to fit in.
NOTE: The recommended diameter of the hole is 26.9mm.
2. Incoming cables should be fed through the backbox from the back or side depending on your installation.
3. Pass all the signal cables from the bullet camera through the hole of rubber seal (#5), and then insert the rubber seal into
the center hole of metal plate.
NOTE: Please identify both sides of the rubber seal. The angled side of the rubber seal must be facing towards the
terminals of the cables and metal plate to prevent water ingress.
4. Refer to 2.3.2 Connecting the Cables to connect the required cables.
5. Install the adaptor plate (#2) in the backbox and tighten the screws.
6. Insert screws (#4) through the bracket’s screw holes and tighten screws into the corresponding hole (#3) of the
adaptor plate (#3).
7. Complete in-ceiling installation with IBP3BBAP-EI.
1
2
3
4
5
Loading ...
Loading ...
Loading ...