Loading ...
Loading ...
Loading ...
12
WITH IBP3BBAP-ES
Also, you can mount the camera to the wall using IBP3BBAP-ES, a Sarix Environmental Surface Mount for bullet. Refer to
the figure below for surface installation with IBP2BB-ES.
FIGURE 2-4: SURFACE MOUNT WITH IBP3BBAP-ES
1. Fix the IBP3BBAP-ES backbox (#1) to the desirable surface by drilling three holes and fastening it with screws.
2. Incoming cables should be fed through the backbox from the back or side depending on your installation.
3. Pass all the signal cables from the bullet camera through the hole of rubber seal (#5), and then insert the rubber seal
into the center hole of metal plate.
NOTE: Please identify both sides of the rubber seal. The angled side of the rubber seal must be facing towards the
terminals of the cables and metal plate to prevent water ingress.
4. Refer to 2.3.3 Connecting the Cables to connect the required cables.
5. Install the adaptor plate (#2) in the backbox and tighten the screws.
6. Insert screws (#4) through the bracket’s screw holes and tighten screws into the corresponding hole (#3) of the adaptor
plate (#2).
7. Complete surface installation with IBP3BBAP-ES.
1
2
3
4
5
Loading ...
Loading ...
Loading ...