Loading ...
Loading ...
Loading ...
56-VOLT LITHIUM-ION PRESSURE WASHER — HPW3200/HPW3200-FC 17
INSTALLING THE HOLDER
BRACKET ASSEMBLY (Fig. 2)
Required Tool (not provided): Phillips
head screwdriver.
1. With the wide opening facing up,
align the holes of the upper holder
bracket with the holes on the upper
side of the pressure washer.
2. Thread two screws into the holes,
then tighten them securely.
3. Install the lower holder bracket following above steps in the similar fashion.
CONNECTING THE HIGH-
PRESSURE HOSE (Fig. 3 – Fig. 5)
You may connect the high-pressure hose
by one of the following ways:
◾
Connect the high-pressure hose to
the water outlet port and the gun
directly through thread joints (Fig. 3a
and 3b);
◾
Connect the high-pressure hose to
the water outlet port and the gun
using two quick-coupler sets to
achieve easily installation/removal.
NOTE: The quick-coupler sets have
been installed onto the water outlet port,
high-pressure hose, gun at the factory.
You could ignore steps 1 and 2, and only
follow them when replacing the quick-
coupler sets.
a
b
3a
a
b
3b
2
Screws
Screws
Upper Holder Bracket
Lower Holder Bracket
Loading ...
Loading ...
Loading ...