Loading ...
Loading ...
Loading ...
Table continued from last page
What to do?CauseProblem/Error
A slight hitting
noise appears.
•• The noise will subside without any
intervention.
If the dryer is out of use for a
long period of time, the
support elements are under
stress at the same point.
The door opens
during drying.
•• Reduce the amount of laundry.Excessive load on the door
(too much laundry in the
drum).
Unevenly dried
laundry.
•• Make sure you have sorted the laundry
by type and thickness, whether you have
added a suitable amount of laundry to
the drum, and whether you have selected
a suitable programme (see PROGRAMME
TABLE).
Laundry of varying types and
thickness, or excessive
amount of laundry.
Laundry not
dried or drying
takes too long
•• Clean the filters (see chapter »CLEANING
AND MAINTENANCE«).
Filters are not clean.
• Make sure there is adequate supply of
fresh air to the dryer; for example, open
the door and/or window.
• Dryer is placed in a closed
room; room that is too cold;
or room that is too small and
the air overheats as a result. • Check if the temperature in the room
where the dryer is installed is too high or
too low.
•• If the load is still wet after completed
drying cycle, an appropriate drying
program should be run again (after
cleaning filters).
Laundry was not sufficiently
wrung or spun.
•• Use a suitable program or extra
functions.
Amount of laundry dried in the
appliance is too large or
insufficient.
• Close the buttons or zippers on the
laundry before drying. Select a suitable
programme (e.g. the program Bedding).
• Laundry (such as bedding)
gets tangled into large balls.
• After the drying process, loosen the
laundry and select an additional drying
programme (e.g. Time (Timed drying
program)).
Drum lighting
error
•• Disconnect the dryer from the power
mains and call an authorized service unit.
There is no lighting when the
dryer door is opened.
48
Loading ...
Loading ...
Loading ...