Hikvision DS-K2601T MAIN BOARD User Manual

Loading ...

Select a card reader to show its parameters on the right.

Edit the card reader parameters.

Note

The displayed parameters may vary for dierent access control devices. There are part of

parameters listed as follows. Refer to the user manual of the device for more details.

Nickname

Edit the card reader name as desired.

Enable Card Reader

Select Yes to enable the card reader for card swiping.

OK LED Polarity/Error LED Polarity/Buzzer Polarity

Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of main board according to the

card reader parameters. Generally, adopts the default sengs.

Minimum Card Swiping Interval

If the interval between card swiping of the same card is less than the set value, the card

swiping is invalid. You can set it as 0 to 255.

Max. Interval When Inpung Password

When you inpung the password on the card reader, if the interval between pressing two

digits is larger than the set value, the digits you pressed before will be cleared automacally.

Enable Failed Aempts Limit of Card Reading

Enable to report alarm when the card reading aempts reach the set value.

Max. Times of Card Swiping Failure

Set the max. failure aempts of reading card.

Enable Tampering Detecon

Enable the an-tamper detecon for the card reader.

Detect When Card Reader is Oine for

When the access control device cannot connect with the card reader for longer than the set

me, the card reader will turn oine automacally.

Buzzing Time

Set the card reader buzzing me. The available me ranges from 0 to 5,999s. 0 represents

connuous buzzing.

Card Reader Type/Card Reader Descripon

Get card reader type and descripon. They are read-only.

Fingerprint Recognion Level

Select the ngerprint recognion level in the drop-down list.

Default Card Reader Authencaon Mode

Access Controller User Manual

Loading ...

Hikvision DS-K2601T MAIN BOARD Access Controller