Loading ...
Loading ...
Loading ...
16
Shark® FLEXBREEZE Fan Instructions
MISTING ACCESSORY
INSTRUCTIONS FOR USE:
1. Carefully align the misting accessory with the circle in the center of
the fan grill, and push it in to install. Do not use excessive force.
2. Screw the end of the misting accessory into the nozzle of a standard
garden hose.
3. Turn on the hose to create mist.
4. To adjust the amount of mist, increase
or decrease the fan speed, or adjust the
water pressure from the hose. Higher water
pressure or fan speed will mean more mist.
5. The valve is open when the mister
accessory is taken out of the packaging.
Rotate the valve clockwise to stop the flow
of water, as shown in the diagram.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE
1. The misting accessory is suitable for OUTDOOR USE
ONLY.
2. The misting accessory will continue to operate when
the fan is powered off. Turn off the water source to
turn off the accessory.
3. DO NOT operate the misting accessory using water
pressure above typical household pressure, 4.1 bar.
4. DO NOT use warm or hot water. Only use cold or room
temperature water.
5. DO NOT handle live electrical products while in range
of the misting stream.
6. Keep non-waterproof electronic equipment and
appliances out of the misting stream.
7. Children should be supervised to ensure that they DO
NOT play with the misting accessory.
8. WARNING: CHOKING HAZARD. Always keep nozzles
and any other small parts out of the reach of children.
9. Cleaning and user maintenance of the misting
accessory shall not be done by children without
supervision.
READ AND SAVE THESE INSTRUCTIONS
INSTRUCTIONS FOR MAINTENANCE:
FOR BEST RESULTS, CLEAN THE MISTING ACCESSORY
ONCE A YEAR, OR AS NEEDED. USING HARDER WATER
WILL REQUIRE MORE FREQUENT CLEANING.
1. Unscrew the misting accessory from the water source,
then pull the other end off the fan grill.
2. Place the accessory on a flat surface and carefully
remove each brass nozzie, one at a time. CAUTION:
Residual pressure may remain in the misting accessory.
3. To remove a nozzle, twist it counterclockwise. Do not
use a wrench or any other tool. WARNING: CHOKING
HAZARD.Keep nozzles out of the reach of children.
4. To flush the misting system, once the nozzles are all
removed, connect the accessory to a garden hose or
other outdoor water source. Aim the accessory away
from yourself or anyone else, then turn on the water and
run it through the system for 30 seconds to flush out any
debris.
5. Soak the nozzles in a solution of undiluted distilled white
vinegar (5% acetic acid by volume) to loosen debris that
may be clogging or restricting the nozzle. DO NOT soak
the nozzles for more than 2 hours.
6. After soaking the nozzles in the solution, rinse them
thoroughly with water.
7. Carefully reinstall each nozzle by twisting clockwise until
you feel resistance.
If your mister becomes less eective or stops working even after following maintenance instructions,
go to sharkclean.com to order replacement nozzles
If your mister becomes less eective or stops working, follow the steps listed in “INSTRUCTIONS FOR MAINTENANCE”.
Do NOT twist nozzles unless they are being removed for cleaning
Loading ...