Loading ...
Loading ...
Loading ...
VIVOTEK
User's Manual - 23
Network Deployment
General Connection (PoE)
When using a PoE-enabled switch
The Network Camera is PoE-compliant, allowing transmission of power and data via a sin-
gle Ethernet cable. Follow the below illustration to connect the Network Camera to a PoE-
enabled switch via Ethernet cable.
1
2
3
4
6
5
8
7
10
LAN/PoE
100~240V
AC
ON
OFF
9
GE LAN GE LAN
PoE Switch
When using a non-PoE switch
Use a 802.3at PoE power injector (optional) to connect between the Network Camera and a
non-PoE switch.
Non-PoE Switch
PoE Power Injector
(optional)
NOTE:
1. The camera is only to be connected to PoE networks without routing to outside plants.
2. For PoE connection, use only UL listed I.T.E. with PoE output.
802.3at
Depending on the requirements of your installation site, select an appropriate power source,
such as an 802.3at PoE (30W) for operating temperature higher than -10ºC. For extremely low
temperature, you will need a power source higher than 35W, such as 24V AC.
If using an 802.3at PoE as the power source, the lowest operating temperature is -20ºC.
Loading ...
Loading ...
Loading ...