Loading ...
Loading ...
Loading ...
ENGLISH
10
3
CLEANING MODE : Try a new recipe or clean up after you're done.
After each use, be sure to dispense any remaining dessert from the Freezing Cylinder
before disassembling the unit for further cleaning. Know that all dessert has been
dispensed when pulling the Dispensing Handle no longer produces dessert.
The CLEANING MODE has two cycles.
Cleaning Cycle 1:
1. To place the unit in CLEANING MODE, press the START/STOP
( / ) button on the control panel, then press the UP or DOWN arrow
on the Control Panel until the Control Panel displays " ".
2. Pour 500 to 800 ml (2 to 3 cups) of fresh water into the
Freezing Cylinder via the Ingredient Funnel.
3. Press the START/STOP ( / ) button to begin the short cleaning process. The Freezing
Cylinder will begin to warm, while the Control Panel begins counting down from "03" to " ".
4. Allow the unit to run for about 30 seconds, then empty the water from the
Freezing Cylinder into a bowl or bucket, and dispose of the old water.
5. While the unit is still running, add 500 to 800 ml (2 to 3 cups) of hot, soapy water into the
Freezing Cylinder via the Ingredient Funnel, then allow the unit to run for about 30 seconds.
6. Empty the soapy water from the Freezing Cylinder into a bowl or bucket, and dispose of the
old water.
NOTE: If you need more time, press the START/STOP button to stop the
current cleaning cycle and the Control Panel will display " ". Press the
START/STOP button again and the cleaning cycle will reset to "03".
7. When Cleaning Cycle 1 is complete, the unit will beep
15 times to indicate the end of the cycle.
Cleaning Cycle 2:
1. Pour 500 to 800 ml (2 to 3 cups) of fresh water into the Freezing Cylinder
via the Ingredient Funnel. Press the START/STOP ( / ) button, and the
Control Panel will begin counting down from "01" to "00".
2. Allow the water to stir for several seconds, then empty the water
into a bowl or bucket, and dispose of the old water.
3. Continue cycling fresh water through the unit until all soap has been rinsed from the
Freezing Cylinder.
NOTE: If you need more time, press the START/STOP button to stop the
current cleaning cycle and the Control Panel will display " ". Press the
START/STOP button again and the cleaning cycle will reset to "01".
4. When Cleaning Cycle 2 is complete, the unit will beep
15 times to indicate the end of the cycle.
5. Now you're ready to try another delicious recipe!
For further cleaning directions, proceed to the CLEANING
& MAINTENANCE section of this manual.
4
CANCEL MODE : Cancel any mode at any time.
To cancel any MODE, simply press the START/STOP ( / ) button on the Control Panel. The
unit will immediately stop that MODE and the Control Panel will display the last number
setting. You may add or subtract time using the UP or DOWN arrows.
NOTE: You will not be able to dispense dessert after engaging CANCEL MODE. To dispense,
press the START/STOP button to add two minutes of time. Dispense after the unit beeps.
Loading ...
Loading ...
Loading ...