Loading ...
Loading ...
Loading ...
Milliamp Process Clamp Meter
Safety Information
3
• The battery door must be closed and locked before you
operate the Product.
• Replace the batteries w
hen the low battery indicator shows
to prevent incorrect m
easurements.
• Do not apply
more than the rated voltage, betwee
n the
terminals or betw
een e
ach terminal and earth ground.
• Measure a
known volt
age first to make sure that the Product
operates correctl
y.
• Use the Clamp only on
insulated conductors. Use caution
around bare conductors or bus bars. To prevent electrical
shock, do not touch the conductor.
• Do not use test leads if the
y are da
maged. Examine the test
leads for damaged insulation, exposed metal, or if the w
e
ar
indicator show
s. Check test lead continuity.
•
Hold the Product behind the tactile barrier. See Figure 1.
• Keep fingers behind the finger guards on the probes.
• Remove all probes, test leads, and accessories before the
battery
doo
r is opened.
• Remove all probes, test leads, and accessories that are not
necessary for the measurement.
• Do not exceed the Measurement Category (CAT) rating of
the lo
w
est rated individual component of a Product, probe,
or accessory
.
• Do not use the Product if it operates incorrectly.
•
Disable the Product if it is damaged.
• Do not make connections on hazardous live conductors in
damp or w
et
environments.
WCaution
To prevent damage to the Meter, do not open it. Do not use a
solvent to clean the Meter, and do not put the Meter in water.
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...