Loading ...
Loading ...
Loading ...
Chapter 39 Multicast
XMG1915 Series User’s Guide
224
39.3 IGMP Snooping
Click SWITCHING > Multicast > IPv4 Multicast > IGMP Snooping to display the screen as shown. See
Section 39.1 on page 222 for more information on multicasting.
Figure 157 SWITCHING > Multicast > IPv4 Multicast > IGMP Snooping
The following table describes the labels in this screen.
Table 116 SWITCHING > Multicast > IPv4 Multicast > IGMP Snooping
LABEL DESCRIPTION
Active Enable the switch button to enable IGMP Snooping to forward group multicast traffic only to
ports that are members of that group.
Querier Select this to allow the Switch to send IGMP General Query messages to the VLANs with the
multicast hosts attached.
Report Proxy Select this to allow the Switch to act as the IGMP report proxy and leave proxy. It will report
group changes to a connected multicast router.
The Switch not only checks IGMP packets between multicast routers or switches and multicast
hosts to learn the multicast group membership, but also replaces the source MAC address in
an IGMP v1/v2 report with its own MAC address before forwarding to the multicast router or
switch. When the Switch receives more than one IGMP v1/v2 join report that requests to join
the same multicast group, it only sends a new join report with its MAC address. This helps
reduce the number of multicast join reports passed to the multicast router or switch.
The Switch sends a leave message with its MAC address to the multicast router or switch only
when it receives the leave message from the last host in a multicast group.
Host Timeout Specify the time (from 1 to 16711450) in seconds that elapses before the Switch removes an
IGMP group membership entry if it does not receive report messages from the port.
802.1p Priority Select a priority level (0 – 7) to which the Switch changes the priority in outgoing IGMP control
packets. Otherwise, select No-Change to not replace the priority.
Unknown Multicast
Frame
Specify the action to perform when the Switch receives an unknown multicast frame. Select
Drop to discard the frames. Select Flooding to send the frames to all ports.
Loading ...
Loading ...
Loading ...