Zyxel XMG1915-10E-EU0101F XMG1915-10E 8-Port 2.5GbE Smart Managed Switch with 2 SFP+ Uplink

Zyxel XMG1915 Series User Guide - Page 178

For XMG1915-10E-EU0101F.

PDF File Manual, 408 pages, Read Online | Download pdf file

XMG1915-10E-EU0101F photo
Loading ...
Loading ...
Loading ...
Chapter 32 Link Aggregation
XMG1915 Series User’s Guide
178
operational port fails, then one of the “standby” ports become operational without user intervention.
Please note that:
You must connect all ports point-to-point to the same Ethernet switch and configure the ports for
LACP trunking.
LACP only works on full-duplex links.
All ports in the same trunk group must have the same media type, speed, duplex mode and flow
control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network
topology loops.
Link Aggregation ID
LACP aggregation ID consists of the following information
1
:
Traffic Distribution Criteria
The Switch supports both unicast and non-unicast traffic (broadcast and multicast) network load sharing
over link aggregation. Load sharing works by statically splitting the traffic based on source or destination
IP/MAC address, and then distributing the load across multiple paths. In link aggregation, this allows the
trunk group (ports) to transmit data as one logical link to a single or group of hosts on the network.
Unicast and non-unicast traffic network load sharing over link aggregation (trunking) is enabled by
default.
Algorithm Types Limitation
The maximum number of link aggregation algorithm types (Criteria) that can link up at the same time
depends on your Switch model. See Table 91 on page 179 for the list of Criteria that your Switch currently
supports.
The following table shows the maximum number of link aggregation algorithm types that can link up at
the same time.
Table 88 Link Aggregation ID: Local Switch
SYSTEM PRIORITY MAC ADDRESS KEY PORT PRIORITY PORT NUMBER
0000 00-00-00-00-00-00 0000 00 0000
Table 89 Link Aggregation ID: Peer Switch
SYSTEM PRIORITY MAC ADDRESS KEY PORT PRIORITY PORT NUMBER
0000 00-00-00-00-00-00 0000 00 0000
1. Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
Table 90 Link Aggregation Algorithm Types Limitation
MODEL LINK AGGREGATION ALGORITHM TYPES (MAXIMUM)
XMG1915 Series 2
Loading ...
Loading ...
Loading ...