VIVOTEK INC.
6F, No.192, Lien-Cheng Rd., Chung-Ho, New Taipei City, 235, Taiwan, R.O.C.
VIVOTEK USA, INC.
2050 Ringwood Avenue, San Jose, CA 95131
VIVOTEK Europe
Randstad 22-133, 1316BW Almere, The Netherlands
T: +31(0)36-5298-434 E: [email protected]
Non-PoE Switch
Data INP+D OUT
100~240V AC
1. Use CAT5 or 5e UTP/STP cables.
2. AC input (100~240V/AC, 50~60Hz), for a max. consumption of 65/100W.
AP-GIC-011A-060/095 PoE Injector
Quick Installation Guide
Model Description
AP-GIC-011A-060 60W high power PoE output
AP-GIC-011A-095 95W high power PoE output
(The PoE output should only be connected to an IP camera. It should not be connected to
non-PoE devices, such as a PC's LAN port)
IMPORTANT
:
INTRODUCTION
CONNECTION
* 1x PoE injector * 1x AC power cord
* 1x Quick Installation Guide
PACKAGE CONTENTS
All specications are subject to change without noice.
Copyright © 2017 VIVOTEK INC. All rights reserved.
Installation Steps:
1. Connect the included AC power cord to the injector. The Power LED (Green) should be lit.
2. Connect the Data IN port to a LAN switch using an Ethernet cable.
3. Connect the Power+Data OUT port to a powered device, i.e., IP camera, using another Ethernet cable. Make sure the
PoE LED (Yellow) is lit.
4. Check if the powered device (IP camera) is working properly. An IP camera may take up to 1 or 2 minutes to power up.
