Loading ...
Loading ...
Loading ...
Do not use washing liquids, sharp or abrasive household
products or any other cleaning agents containing soda.
• Make sure that the pipes for the circulation of the
refrigerant are not damaged in any way during installation
of the appliance.
• The appliance must only be used for the purpose for which
it is intended.
• The appliance must be placed on a firm, level surface.
This is the only way to ensure that the refrigerant can
circulate freely and thus ensure that your appliance will
work efficiently.
• If possible, place your appliance in a cool, well-aired,
dry room.
• Do not place your appliance in direct sunlight, nor in a
room at high temperature.
• Do not place your appliance in the vicinity of any sources
of direct heat such as heating, ovens, cooking stove etc.
(This would mean the compressor would have to work
harder and as a result the power consumption would be
considerably higher).
Do not place any appliances, such as
microwaves, toasters etc. which give off heat on the
appliance.
• Never obstruct the ventilation grille.
• Always pull out the plug itself and never pull the cable
when cutting the appliance off from the mains supply.
• Leave the appliance standing in its final position for
at least 2 –4 hours before switching it on, so that the
circulation of the refrigerant stabilises and no
operating problems occur.
3
FITTING FURNITURE BOARD TO APPLIANCE DOOR
Place the mounting bracket on furniture board and
position it a
ccordingly (Fig. 12). The distance between
the furniture board and the underside of the worktop
should be 5 mm (Fig. 13). Attach the mounting bracket
using suitable screws supplied in the installation kit. Pull
out the mounting bracket cover and screw in the two
special screws (2) in the appliance doors (Fig. 14).
Attach furniture board with the fixed mounting bracket to
the appliance door. Secure the furniture board with
suitable nuts (item 3, Figure 14). Make sure the furniture
board assembly is positioned correctly relative to the
appliance (Fig. 15). Using the supplied screws, attach
the furniture board assembly to the bottom of the
appliance door (Fig. 15). Replace the mounting bracket
cover in its original location.
Loading ...
Loading ...
Loading ...