Loading ...
Loading ...
Loading ...
- 36 - - 37 -
The location to install the decorative cover
bracket should generally be 29 15/16 " (760
mm) above the central point of the duct bracket.
If the distance between the ceiling and duct
bracket equals to or is less than the value,
secure the decorative cover bracket on the wall
right under the ceiling. If the distance is more
than the value, taller decorative covers (27
9/16" (700 mm) and 35 7/16" (900 mm) in height
respectively) need to be bought separately.
Drill Ø8 hole at the screw hole marks with
electric drill and embed expansion tubes.
4. Secure the duct bracket and decorative cover
bracket to the wall with corresponding screws
and tighten the screws. Make sure the bracket
is leveled.
Caution: One of the screws for duct bracket
must be fastened to the wooden beam.
5. Fasten the gasket seal and duct cover to
the range hood outlet with four M4 x 18 screws
and set four cover screws at the corresponding
places. Fix two bases at corresponding
positions on the back of the range hood with
base screws.
6. Remove the protective film of the stainless
steel surface and Grease Cup at both sides of
the range hood.
7. Lift and position the hood onto the mounting
screws. Make sure the hood is stable and
leveled by using a spirit level. Install the safety
buffer bafe above the hood.
Caution: Two installers are required to ensure
safe installation.
8. Secure the duct to the duct cover and seal the
connection with aluminum tape.
Make sure the hood is leveled. Install the Grease
Cup, and plug the appliance for a test run.
9. Tear off the protective lm over the decorative
cover and the blower housing; then install the
decorative cover onto the brackets. Push the
blower housing downward and lock it to the cover
screws.
10. Install the smoke bafe plate.
①
Remove the "Installation Tips" on the smoke
bafe plate;
②
Take out one screw in the accessory bag
(keep another screw for backup);
③
Open the Smoke Baffle Plate to the
maximum angle;
④
Fix the left bracket with the screwdriver and
screw;
⑤
Install Collision Avoidance Elements on both
left and right corners of the Smoke Bafe Plate.
11. Make sure the hood is leveled. Install the
Grease Cup, and plug in the appliance for a test
run.
Warning: Please wear the qualified protective
gloves in operation.
6.6 Test Run After Installation:
1. Press the "
Lighting" button to check if the
light is normal, then press the " Lighting" button
again to reset, and the light will be turned off.
2. Press the " LOW-SETTING FAN/POWER"
button to check the motor.
If any of the following malfunctions occurs, unplug
the hood immediately and re-check the installation
process. (If the malfunction continues, contact our
authorized service center as soon as possible.)
(1) The hood vibrates violently.
(2) The impeller does not work.
(3) The impeller grates while rotating.
(4) The motor makes strange sounds.
3. press the " LOW-SETTING FAN/POWER"
button again to reset, and the motor will stop
running.
Loading ...
Loading ...
Loading ...