Loading ...
Loading ...
Loading ...
MX101520—UN—09JUN20
3. Locate the left-hand and right-hand reservoirs at the rear of the
machine. Each transmission has its own reservoir.
4. The reservoirs have two marks, FULL (A) and ADD (B). Check
level with uid cold.
5. If oil level is below the ADD line (B), clean area around reservoir
cap and remove cap (C).
6. Remove foam insert.
7. Add oil until level is at FULL mark (A) on reservoir.
8. Install foam insert.
9. Install cap (C).
10. Start engine.
11. Operate machine forward and in reverse several times.
12. Park machine safely on a level surface. (See Parking Safely in the
Safety section.)
13. Wait for hydraulic oil to cool.
14. Check oil level again. Add oil if necessary.
TH84124,00001FB-19-29JUN20
Changing Transaxle Oil and Filter
The transaxles on these models require no oil and lter changes. The
oil level must be maintained at the FULL line on the reservoir.
MG39705,000020B-19-16JUL19
Checking and Adjusting Neutral Creep
Check neutral creep with the engine running, motion control levers in
the start/shutdown position, park brake o, and machine on level
ground.
If the machine creeps forward or reverses while motion control levers
are in the start/shutdown position, adjust the motion control linkages:
1. Park machine safely. (See Parking Safely in the Safety section.)
2. Remove style panel (A) for better access to adjustment
components (if desired). (See Removing and Installing Style Cover
in the Service Miscellaneous section.)
MX101524—UN—10JUN20
3. On the linkage side needing adjustment (right side shown), remove
spring locking clip (C) and rod end (D) from pivot pin (E).
MX101457—UN—01MAY20
4. Turn rod end (D) on rod (F) clockwise to decrease forward creep
and counterclockwise to decrease reverse creep.
5. Repeat procedure, as necessary, on the opposite side. Install rod
ends back onto arms and secure with spring locking clips.
SB31882,00003FE-19-29JUN20
Adjusting Tracking
If the machine does not track in a straight line while going in full
forward position, the tracking requires adjustment.
1. Park machine safely. (See Parking Safely in the Safety section.)
MX101452—UN—29APR20
2. Acquire the onboard tool (A) with 13 mm wrench.
Service Transmission
41
Loading ...
Loading ...
Loading ...