Loading ...
Loading ...
Loading ...
highest position rst. If uncomfortable, adjust accordingly for the
operator.
● For highest lever position, use holes (A).
● For lowest lever position, use holes (B).
4. You can also adjust each motion control lever slightly forward or
rearward within slotted holes.
SB31882,00003BD-19-23JUN20
Adjusting Cutting Height
Cutting height can be adjusted from approximately 25––100 mm (1––4
in). When mower deck is in transport position cutting height is
approximately 100 mm (4 in).
MX101389—UN—02APR20
1. Raise mower deck:
● Push down on lift pedal (A) and lock in the raised position
(transport). When in the transport position, the lever (B) is raised
over the styling.
2. Insert the deck height pin tool (C) in the proper hole for the desired
height of cut.
3. Lower mower deck:
● Push down on lift pedal (A) and then push down on lever (B),
release lift pedal rearward until the deck achieves the selected
height.
SB31882,00003BE-19-08JUN20
Adjusting Mower Wheels
CAUTION: Avoid injury! Rotating blades are dangerous.
Before adjusting or servicing mower:
• Disconnect spark plug wires or battery negative (-) cable to
prevent engine from starting accidentally.
• Always wear gloves when handling mower blades or
working near blades.
IMPORTANT: Avoid damage! If the mower deck wheels are
adjusted incorrectly, the mower deck can be damaged.
• Wheels must not ride on ground supporting mower weight.
• Check wheel adjustment each time cutting height is
changed.
1. Park machine safely on a level surface. (See Parking Safely in the
Safety section.)
2. Inate tires to correct pressure.
3. Press the mower deck lift pedal, and lock in the transport position.
4. Adjust mower deck wheels to correct height:
.
MX101461—UN—01MAY20
Position 1 (A) 25––38 mm (1––1-1/2 in) Height of Cut
Position 2 (B) 38––50 mm (1-1/2––2 in) Height of Cut
Position 3 (C) 50––76 mm (2––3 in) Height of Cut
Position 4 (D) 76––101 mm (3––4 in) Height of Cut
● Remove nut (E). Pull the carriage bolt (F) out until end of bolt clears
the outer wall of the depth gauge wheel bracket (G). Slide the bolt
and wheel assembly to the desired position. Push the bolt back
through the outer wall of bracket. Install nut (E) and tighten to
specication.
Specication
Mower Wheel Nut—Torque. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 N·m (18 lb·ft)
NOTE: The onboard tool with 13 mm wrench is located in the styling
tool box area.
SB31882,00003C7-19-16JUN20
Testing Safety Systems
MXAL42804—UN—09APR13
CAUTION: Avoid injury! Engine exhaust fumes contain
carbon monoxide and can cause serious illness or death.
Do not run an engine in an enclosed area, such as a garage,
even with doors or windows opened.
Move the machine to an outside area before running the
engine.
The safety systems installed on your machine should be checked
before each machine use. Be sure that you have read the machine
operator manual and are familiar with the operation of the machine
before performing these safety system checks.
Operating
20
Loading ...
Loading ...
Loading ...