Loading ...
Loading ...
Loading ...
50
Trigger alarm condition: all or mask off can be selectable.
All: Alarms will be triggered when the camera detects a face (with/without a mask).
Mask off: Alarms will be triggered when the detected person is not wearing a mask on the face.
4. Set alarm detection area.
Click “Draw Area” and drag the border lines of the rectangle to modify its size. Move the
rectangle to change its position. Click “Stop Draw” to stop drawing the area. Click “Clear” to
clear the area. Then set the detectable face size by defining the maximum value and the
minimum value (The default size range of a single face image occupies from 3% to 50% of the
entire image).
5. Advanced settings. Choose the snapshot interval and number as needed to avoid
capturing multiple similar pictures in a very short period of time.
Deduplication Period: If 30 seconds is selected, the camera will capture the same target once
every 30 seconds during its continuous tracking period.
Snapshot Number: If the snapshot number is enabled and set (eg. 3), the camera will capture
the same target once every 30 seconds and it will capture this target 3 times at most during its
continuous tracking period. If the snapshot number is disabled, the camera will capture the
same target once every 30 seconds until the target disappears in the detected area.
6. Set the schedule of the face detection. The setup steps of the schedule are the same as
schedule recording setup (See Schedule Recording Settings).
Loading ...
Loading ...
Loading ...