Loading ...
Loading ...
Loading ...
Installation
43
EN
• 380-415 V 2N~ / 220-240 V 3~
4 x 4 mm² four-core* cable.
• 220-240 V 1N~
3 x 6 mm² three-core* cable.
*use the jumper provided
The diagram below illustrates the power
supply terminal from below, with no cables
connected. Terminals 4 and 5 must be
connected at all times.
Fixed connection
Fit the power line with an omnipolar circuit
breaker in compliance with installation
regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
Connection with plug and socket
Make sure that the plug and socket are of
the same type.
Avoid using adapters and shunts as these
could cause overheating and a risk of
burns.
Testing
At the end of installation, carry out a brief
inspection test. If the hob fails to operate,
after checking that you have carried out the
instructions correctly, unplug the appliance
and contact Technical Support.
The values indicated above refer
to the cross-section of the internal
conductor.
Run the power cable in the rear
part of the unit. Take care to ensure
that it does not come into contact
with the lower part of the hob or
any oven built-in underneath it.
Be careful when connecting
additional electrical appliances.
Connection cables must not come
into contact with hot cooking
zones.
Loading ...
Loading ...
Loading ...