Loading ...
Loading ...
Loading ...
Installation
40
(seen from below)
90 cm
6. Remove the glass hob top.
Replacing the nozzles
1. Unscrew screw A and push air
regulator B as far as it will go.
2. Use a spanner to remove the nozzles C
and install the new ones for the required
gas supply, following the indications
given in the relevant table (see “Burner
and nozzle characteristics tables”).
3. Adjust the air flow by moving the air
regulator B to obtain the distance D
given in the corresponding table (see
“Burner and nozzle characteristics
tables”).
4. After adjusting each burner, reassemble
the appliance correctly.
Adjusting the minimum setting for natural
or town gas
1. Light the burner and turn it to the minimum
position.
2. Extract the gas cock knob and turn the
adjustment screw next to the tap rod
(depending on the model) until the
correct minimum flame is achieved.
3. Refit the knob and verify that the burner
flame is stable.
4. Turn the knob rapidly from the maximum
to the minimum setting: The flame should
not go out.
The nozzle tightening torque must
be no more than 3 Nm.
Loading ...
Loading ...
Loading ...