Loading ...
Loading ...
Loading ...
en Software update
10
It consists of two parts, which can be easily removed. If
it is removed from a metal surface, the bottom part
may remain fixed to this surface. Put both parts back
together again to use it.
6.1 Positioning and operating Twist Pad®
1.
Use
to switch on the hob.
2.
Place the knob in the central area of the control
panel at the point marked with on the glass.
3.
To switch on a cooking zone, push the rotary knob
at the level of the required cooking zone.
4.
Turn the knob and select a power level.
6.2 Instructions for use
A strong magnet is located inside the rotary knob. You
should therefore note the following:
¡ Keep the rotary knob away from magnetic data car-
riers such as credit cards and cards with magnetic
strips. This may damage the data carrier. The mag-
net may also cause faults on televisions and
screens.
¡ Metal particles stuck to the bottom may scratch the
surface of the hob. Always keep the rotary knob
clean. Soiling may impair its function. See "Cleaning
the knob". →Page23
6.3 Removing Twist Pad®
You can remove the rotary knob from the cooking zone
during the cooking process.
If you remove the rotary knob, the Pause function is
switched on for 10 minutes. →Page18 If you do not
reset the rotary knob to its position before this time
elapses, the hob switches off.
WARNING‒Risk of fire!
If you place a metal object on the area of the rotary
knob during these 10 minutes, the cooking zone may
continue to heat up.
▶ Always switch off the cooking zone at the main
switch.
6.4 Operation without rotary knob Twist
Pad®
If you lose the rotary knob, or in other situations, you
can operate the hob without the TwistPad®. Proceed
as follows:
1.
Use
to switch on the hob.
2.
Within the next 5 seconds, press and hold and
at the same time for 4 seconds. A warning tone
sounds and lights up.
3.
Press repeatedly until the display for the required
hob lights up.
4.
Then set the required power level using or .
a The cooking zone is switched on and heats up.
Notes
¡ In this mode, only the basic function for the hotplate
is available.
¡ You can always position the rotary knob in the pro-
gramming zone again.
Software update
7 Software update
If the appliance is connected to HomeConnect, some
functions may be available with a software update.
More information on the availability of additional func-
tions can be found on the website www.neff-interna-
tional.com
Operating modes
8 Operating modes
You can use your appliance in air extraction mode or
circulating-air mode.
8.1 Air extraction mode
The air which is drawn in is cleaned by the grease fil-
ters and conveyed to the exterior by a pipe system.
Loading ...
Loading ...
Loading ...