Loading ...
Loading ...
Loading ...
User Manual of Thermal Smart Linkage Tracking System
22
Chapter 4 Network Connection
Before you start:
If you want to set the network speed dome via a LAN (Local Area Network), please
refer to Section 4.1.
If you want to set the network speed dome via a WAN (Wide Area Network),
please refer to Section 4.2.
4.1 Set the Camera over the LAN
Purpose:
To view and configure the camera via a LAN, you need to connect the network
camera in the same subnet with your computer, and install the SADP or client
software to search and change the IP of the network camera.
For the detailed introduction of SADP, please refer to Appendix.
4.1.1 Wire over the LAN
The following figures show the two ways of cable connection of a network camera
and a computer:
Purpose:
After completing the installation of Smart Linkage tracking system, you need to
set the function configurations and related parameters. Make sure that the system
is properly connected with your PC. Two methods are available for the system
connection, as shown in Figure 4-1.
The following figure shows the cable connection of network speed dome.
Client Software
Client Software
Network Cable
(Straight-Through
Wired Cables)
Network Cable
(Crossover Wired
Cables)
Figure 4-1 Connecting Directly
Loading ...
Loading ...
Loading ...