Loading ...
Loading ...
Loading ...
1
Getting Start
This section provides an introduction to the web-based configuration utility,
and covers the following topics:
• Powering on the device
• Connecting to the network
• Starting the web-based configuration utility
⚫ Power
Power down and disconnect the power cord before servicing or wiring a
switch.
Do not disconnect modules or cabling unless the power is first switched off.
The device only supports the voltage outlined in the type plate. Do not use
any other power components except those specifically designated for the
switch.
Disconnect the power cord before installation or cable wiring.
The switch is powered by the AC 100-240 V 50/60Hz internal high-performance
power supply. It is recommended to connect the switch with a single-phase
three-wire power source with a neutral outlet, or a multifunctional computer
professional source.
Connect the AC power connector on the back panel of the switch to the external
power source with the included power cord, and check the power LED is on.
Rear View AC Power Socket
Loading ...
Loading ...
Loading ...