1. Home
  2. Hikvision
  3. Hikvision DS-2SF8C442MXG-EL/26 User Manual
  4. Page 52

Hikvision DS-2SF8C442MXG-EL/26 TandemVu 8C Series Panoramic 4 MP 42X DarkFighter Network Speed Dome

User Manual - Page 52

For DS-2SF8C442MXG-EL/26.

PDF File Manual, 142 pages, Read Online | Download pdf file

DS-2SF8C442MXG-EL/26 photo
Loading ...
Loading ...
Loading ...
Before You Start
People Density is supported by the panoramic channel. You need to select People Density for
Camera 02 or Camera 03 on VCA Resource page rst.
Steps
1.
Enable the funcon in Conguraon → People Density → Rule .
2.
Set a detecon area.
-
Click
, and click on the live image to dene the boundary of the detecon area. Le click to
nish drawing.
-
Click
to clear selected areas.
-
Click
to clear all the areas.
Note
Up to 8 areas can be set at the same me.
3.
Select an area from the list and set the target size as Large-size Target or Small-size Target.
-
Click
, and a frame of 40 × 40 pixels will be displayed in the live image. If the shoulder of
the target is wider than the frame, you should select Large-size Target.
-
Click
, and a frame of 20 × 20 pixels will be displayed in the live image. If the shoulder of
the target is shorter than the frame, you should select Small-size Target.
Note
If the shoulder width is between the two modes, adjust installaon posion and device angle to
meet the requirements.
4.
Dene the Density Level by the number of people in the detecon area and the target pixel
rao.
Number of
People
Set the range for each level by inpung the lower limit of the number of
people in the detecon area.
Target Pixel
Rao
Target pixel rao refers to the rao of the detecon area occupied by
people. Check Enable Target Pixel Rao and input the lower limit of target
pixel rao for each level.
Note
●
Up to three levels can be congured. The density increases from level 1 to level 3.
●
The target pixel rao is oponal. When it is enabled, both the set number of people and the
rao should be met to reach the density level.
Example
Set the people number of Level 1 as 10, Level 2 as 100, and Level 3 as 1000. When the number
of people in the detecon area is less than 10, the alarm is not triggered. When the number of
people is between 10 and 100, Level 1 alarm is triggered. When the number of people is
between 100 and 1000, Level 2 alarm is triggered. When the number exceeds 1000, Level 3
alarm is triggered.
5.
Click Save.
TandemVu PTZ Camera User Manual
40
Loading ...
Loading ...
Loading ...