Loading ...
Loading ...
Loading ...
19
TROUBLESHOOTING
You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
Troubleshooting Guide
PROBLEM
POSSIBLE CAUSE
REMEDY
Appliance
does not
operate.
Appliance is not connected to a
power supply.
The appliance is turned off.
Tripped circuit breaker or blown fuse
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or replace
fuse.
Appliance is
not cold
enough.
The temperature is not set correctly.
The ambient temperature could
require a lower temperature setting.
Drawers were opened too often.
A drawer was not closed completely.
Drawer is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or
too dusty.
Check the set temperature.
Set a lower temperature.
Do not open drawers more often
than necessary.
Close drawer properly.
Check the seal and clean or
replace.
Clean the condenser when
necessary.
Clear the obstructions and clean off
the dust.
Appliance
turns itself on
and off
frequently.
The room temperature is higher than
average.
A large amount of food has been
added to the unit.
Drawers are opened too often.
A drawer is not closed completely.
A drawer gasket does not seal
properly.
Put the appliance in a cooler place.
Leave the appliance to work for a
while until the set temperature has
been reached.
Do not open the drawers more
often than necessary.
Close drawer properly.
Check the drawer seal and clean or
replace it.
Vibrations
The appliance is not properly leveled.
Level the appliance with the
adjustable feet.
The appliance
seems to
make too
much noise.
The rattling noise may come from the flow of the refrigerant, which is normal. As
each cycle ends, you may hear gurgling sounds caused by the flow of refrigerant
in your appliance.
If temperature fluctuations occur, the contraction and expansion of the inner walls
may cause popping and crackling noises.
The appliance is not properly leveled.
Level the appliance with the
adjustable feet.
Drawer
will not close
properly.
The appliance is not properly leveled.
The gaskets are dirty.
The racks or bins are out of position.
Level the appliance with the
adjustable feet.
Clean the drawer gaskets.
Check the racks and bins and refit
correctly.
Display “E1”,
Error codes.
Try resetting the controls by
Loading ...
Loading ...
Loading ...