Loading ...
Loading ...
Loading ...
ADVANCED CONFIGURATION
119
5. From the side menu choose the
SCLK input and the SDA Input.
SCLK
CH1~CH2
SDA
CH1~CH2
Include R/W in
address
To configure whether you want the
R/W bit to be included in the
address, press Include R/W in
address and set to Yes or No in the
side menu.
R/W Bit
Yes, No
CAN Serial Bus Interface
The controller area network (CAN) bus is a half duplex 2 wire
synchronous serial interface. The CAN bus is a multi-master
communication system that relies on arbitration to solve contention
issues. The MDO-2000A series supports both CAN 2.0A and 2.0B.
The CAN bus uses two wires, CAN-High and CAN-Low. These
wires are voltage inverted, and as such, the MDO-2000A Series
only needs one wire, CAN-High or CAN-Low for decoding.
Panel operation
1. Connect the bus signal (CAN Input) to one of
the oscilloscope’s analog or digital channels.
Connect the ground potential to one of the
probes’ ground clip if you are using the analog
channels or to the ground connector of the
Digital card if you are using the digital
channels.
GND
CAN input
X
10
X
1
Analog
2. Press the Bus key.
BUS
B
Loading ...
Loading ...
Loading ...