Loading ...
Loading ...
Loading ...
AGRAS T50/T25
Unmanned Aircraft Flight Manual
©
2024 DJI All Rights Reserved.
61
5. Tap , check the aircraft status and task settings, set an appropriate Connection Routing/
RTH Altitude, and move the slider to launch the aircraft. The aircraft will perform the
operation automatically.
The Connection Routing and RTH altitude and speed can be adjusted under Pre-Task
Auto Check and Aircraft Settings. If it is adjusted in one location, it will automatically
be updated in the other location too.
Users can enable or disable Connection Route Altitude in Pre-Task Auto Check or
Aircraft Settings. When enabled, the aircraft will fly to the first waypoint at the pre-
set Connection Route altitude and return to the flight route with this altitude after the
operation is paused and resumed. When disabled, the aircraft will arrive at the first
waypoint with the pre-set height above the vegetation.
Only take off in open areas and set an appropriate auto-takeoff height according to
the operating environment.
The operation is automatically cancelled if the motors are started before beginning
the operation. You will need to recall the operation in the task list.
Once started, the aircraft flies to the starting point of the route and locks its heading
in the direction of the first turning point for the duration of the flight route. During
operation, users cannot control the aircraft heading via the control stick.
Users can adjust the spray amount, flying speed, and the height above vegetation in
the app.
An operation can be paused by moving the control stick slightly. The aircraft will
hover and record the breakpoint, and then the aircraft can be controlled manually.
To continue the operation, select it again from the Executing tag in the field list, and
the aircraft will return to the breakpoint automatically and resume the operation. Pay
attention to aircraft safety when returning to a breakpoint.
Users can set the action the aircraft will perform after the operation is completed in
the app.
System Shutdown
After landing, push the throttle stick down and hold to stop the motors. Press the power button
and then press and hold to power off the aircraft and remote controller.
Post-Flight Inspection
1. Make sure that the aircraft is powered off. Remove the battery from the aircraft and store it
properly.
2. Check the aircraft structure, clean the dirt and dust, and replace any loose or damaged
parts.
3. Make sure that there is no residue in the spray/spread tank and the whole spraying/
spreading system.
4. Make sure that the aircraft is folded correctly for transportation.
5. Make sure that the battery connector on the aircraft is clean and dry.
Loading ...
Loading ...
Loading ...