Loading ...
Loading ...
Loading ...
Initial Setup and Configuration
Warm-Up the Product 2
2-7
Warm-Up the Product
It is recommended that the Product be warmed up before use to stabilize the
environmentally controlled components. This will ensure the best performance to the
specification listed in Chapter 1. Sufficient warm-up times are as follows:
• If the Product has been powered off for 30 minutes or more, let it warm-up for 1 hour
or more.
• If the Product has been powered off for less than 30 minutes, let it warm-up for a
minimum of two times the length of time it was powered off. For example, if Product
has been turned off for 10 minutes, let it warm-up for 20 minutes.
Configure the Product
Use the Instrument Setup menu to configure the Product. To open the Instrument Setup
menu, push
on the front panel. To change a setting, highlight the setting then use
the menu softkeys shown on the display to edit the settings.
Table 2-2 shows the menu items and selections available in the Instrument Setup menu.
Table 2-2. Instrument Setup Menu
Menu Item Description Selections Available
Language
Changes the display language.
Note
If the incorrect language is set by accident, push
then push . This temporarily resets the language to
English.
English
中文
Français
Deutsch
Portugués
Español
Русский
日本語
한국어
Firmware
Shows the firmware version installed, model number, and
serial number
--
Date
Changes the date and date format shown on the top-right
corner of the display. This date is also used for
timestamps in the data log.
MM-DD-YYYY
YYYY-MM-DD
DD/MM/YYYY
Time
Changes the time and time format shown on the top-right
corner of the display. This time is also used for
timestamps in the data log.
12H or 24H
Decimal
Format
Changes the decimal format to show a comma or
decimal.
Period (0.000) or
Comma (0,000)
Display
Brightness
Changes the display brightness level. High, Med, or Low
Keypad Beep
Turn on or turn off the key beep that sounds when a key
is pushed.
ON or OFF
1.888.610.7664 sales@GlobalTestSupply.com
Fluke-Direct.com
Loading ...
Loading ...
Loading ...