Loading ...
Loading ...
Loading ...
BRAKE SYSTEM BREAK-IN
Apply only moderate braking force for the first 50 stops. Aggressive or overly
forceful braking when the brake system is new could damage brake pads and
rotors.
Perform the following steps on a new vehicle or anytime brake pads are
replaced on the vehicle:
1. In an appropriate riding area, safely slow the vehicle with moderate (70%)
braking from 30 mph (50 km/h) down to 5 mph (8 km/h). Do not stop
completely in order to keep air flowing through the brakes.
2. Repeat for 10-20 cycles and let the brakes cool between each cycle by riding
your vehicle approximately 0.25 miles (400 m).
3. After you have completed all 20 cycles, ride the ATV for awhile to cool the
braking system to avoid overheating the brakes.
4. Stop the vehicle and put the transmission in PARK. DO NOT apply the
parking brake until the brake system has fully cooled.
PVT BREAK-IN (CLUTCHES/BELT)
Always break in the clutches and drive belt of new vehicles, as well as after a
belt replacement.
A proper break-in of the clutches and drive belt will ensure a longer life and
better performance. Break in the clutches and belt by operating at slower
speeds during the break-in period as recommended. Pull only light loads. Avoid
aggressive acceleration and high speed operation during the break-in period.
If a belt fails and you need to replace it, always clean all debris from the PVT
intake and outlet duct, the clutch, and the engine components.
60
OPERATION
Loading ...
Loading ...
Loading ...