Loading ...
Loading ...
Loading ...
If a high pressure water system is used for cleaning, exercise extreme caution.
The maximum pressure should not exceed 3000 psi (20684.27 kPa), 2.5 GPM
(567.81 LPH) with a 40° pressure washer nozzle. Make sure to keep the
pressure washer nozzle 2 ft (60 cm) from the vehicle and away from the surface
being cleaned. High water pressure could remove paint and labels and damage
radiator fins and/or impair a radiator’s effectiveness. High water pressure with a
hot temperature could also damage brake lines with the nozzle at a close
proximity even with a short exposure time. Avoid directing the water stream at
the following items:
• Wheel bearings
• Radiator
• Transmission seals
• Brakes / brake lines
• Body panels
• Labels and decals
• Electrical components and wiring
• Air intake components
• Throttle and shift cables and controls
• Seats
If warning and safety labels are damaged, contact your POLARIS dealer for free
replacement.
Grease all zerk fittings immediately after washing. Allow the engine to run for a
while to evaporate any water that may have entered the engine or exhaust
system.
POLISHING THE VEHICLE
POLARIS recommends the use of common household aerosol furniture polish
for polishing the finish on your POLARIS vehicle. Follow the instructions on the
container.
POLISHING TIPS
• Avoid the use of automotive products, some of which can scratch the finish of
your vehicle.
• Always use clean cloths and pads for cleaning and polishing. Old or reused
cloths and pads may contain dirt particles that will scratch the finish.
STORAGE TIPS
NOTICE
Starting the engine during the storage period will disturb the protective film
created by fogging and damage could occur. Never start the engine during the
storage period.
CLEAN THE EXTERIOR
Make any necessary repairs and clean the vehicle as recommended. See the
Washing the Vehicle section.
140
MAINTENANCE
Loading ...
Loading ...
Loading ...