Loading ...
Loading ...
Loading ...
AXIS P3367–V Fixed Dome Network Camera
Video and Audio
• Auto to set the shutter speed automatically. If required, use Max shutter to limit the shutter speed to prevent the frame
rate from being reduced. For example, to get 30 fps, set Max shutter to 1/30.
• Fixed to use a fixed shutter speed.
Gain, measured in decibel (dB), is the amount of amplification applied to the image. A high gain ma y provide a better image in low
light situations but will increase the amount of image noise.
Set Gain to
• Auto to set the gain automatically. If required, use Max gain to limit the applied gain.
• Fixed to use a fixed gain.
When Shutter and Gain are both set to Auto, it is possible to set the Priority between low motion blur and low noise manually and to
use a different Priority in Normal Light and in Low Light.
Example
Consider an area where people or vehicles m ove during the day, but where there should be no m o v ements during night. To be able to,
for example, rec ognize faces or license plates, move the normal light priority slider toward low motion blur. At nightti m e, motion
detection is more important than identification. Motion blur is acceptable and since low light can cause a lot of noise, move
the low light priority slider toward low noise.
Example
If storage space or bandwidth is limited, try using a lower gain. This will reduce image noi se and produce smalle r image fi les.
Iris adjustment
Select Enable automatic iris adjustment to automati ca lly compensate for changing light conditions. This option is not available
if a fixed iris is used.
Use the Iris adjustment slider to set the preferred F-value. The scale represents the amount the iris is open. If set to 0, the iris
is opened as much a s possible. If set to 100, the iris is closed as much as p ossible. The actual F-value is shown belo w the
slider. If automatic iris adjustment is enabled, the iris will stay at this pos
ition as long as light conditions are favorable. If light
conditions change, the iris will adjust itself to the best iris settings. If automatic iris adjustment is disabled, the iris will lo ck on
the set posi tion regardless of light condi tions
Day/Night
The IR cut filter prevents infrared (IR) light from reaching the image sensor. In poor lighting conditions, for example a t night, or
when using an IR lamp, set the IR cut filter to Off. This increases light sensitivity and allows the product to “see” infrared light. The
image is shown in black and white when the IR cut filter is off.
If using automatic Exposure control,settheIRcutfilter to Auto to automatically switch between On and Off accordingtothe
lighting conditions.
If using IR illuminations, select Enable focus adjustment for IR illumination.
View Areas
A view area is a cropped part of the full v iew. Each view area is treated as a video source in Live View and has its own video
stream and PTZ settings.
To enable view areas, go to Video & Audio > Camera Settings and select Enable View Areas.
When setting up a view area it is recommended that the video stream resolution is the same size as or smaller than the view area
size. Setting the video stream resolution larg er than the view area size implies digitally scale d up video after sensor capture,
requiring more bandwidth without adding image information.
To add a new view area:
1. Go to Video & Audio > View Areas.
19
Loading ...
Loading ...
Loading ...